Hi Micha,

Thanks for timely reply.

We successfully flashed u-boot in tribbox.

Thanks

Vinod.K

Hi all,
        I am trying to flash u-boot to the flash memory of tribbox and i face the following problems

1) when using kermit to send u-boot.bin
   
   send u-boot.bin

   Error:
         warning: flash_make_cmd - unsupported little endian problem

2) I am using u-boot loader for st7100mboard . Is that the problem ?
   Is the u-boot loader should be configured for tribbox ?  If yes

3) How to configure u-boot loader for tribbox.

Please help me out of this problem.


Thanks and Regards
Vinod K

Dear All,

1) Can I load "u-boot-1.1.2_stm22_0017_stb7100ref" into flash memory of tribbox.

2) Is the u-boot supplied with the tribbox same as u-boot version mentioned above ?

 It would be of great help to me if i get any suggestions on this.


Regards,
Vinod K

Dear All,

Initially I brought up the tribbox to load uImage from a PC through TFTP and then load FS through NFS. Later when we tried to boot it we faced some problem. We pressed CTRL+C. This erased the flash at that time. After that we are not able to get any message from the serial port.

We also were trying to download the uboot code using the torrent (using Tribler) provided by the tribbox website. But it was not able to find any peers with the file.

We have provided the queries we have on tribbox below;

1. Please let us know where we can properly get/download the uboot code.

2. Also please let us know the proper procedure for burning the bootloader in flash for tribbox using JTAG.

3. We have ST Micro Connect device. Can this be used for JTAG emulation purposes?

4. Is the 20 pin connector ‘CN1’, the JTAG connector?

Regards ,

Vinod.K